Typical applications: Suitable for headphone cables, USB cables, multi-core cables, communication cables, flat cables, and signal cables for bending resistance tests. The test method is: the motor is installed vertically, one end of the cable is clamped on the motor rotating fixture, and the other end is hung with a weight (load) to rotate left and right to evaluate whether the cable is conductive after N tests.

Purpose: This machine is suitable for 45-degree rotation life test of power cords, headphone cords, and new data cables of mobile phones, e-books, tablet computers, electronic dictionaries, laptops, headband headphones, etc.

It is suitable for bending resistance test on headphone cable.USB cable,multicore cable conductor,flat cable and signal line,etc.The test method is as follows:Firstly,clamp one end of the wire rod and fasten it to the rotation clamp. Then have it make a horizontal rotaion with hanging load to evaluate whether wire rod conduction is good after numerous test cycles.

scop:

Este potrivit pentru testul de îndoire a cablului căștilor, cablului USB, cablului multi-core, cablului de comunicație, cablului plat și cablului de semnal.

Metoda de testare este următoarea: un capăt al sârmei este scurt este scurt, fixat pe discul rotativ și rotit la stânga și la stânga și la dreapta sub o anumită sarcină de ridicare, astfel încât să se evalueze dacă sârma are o conducție bună după N ori de testare.

Standard de testare:

EIA-364-41D procedura de testare a flexiei cablurilor pentru conectori electrici.

Purpose:

It is suitable for testing the winding or torsion of various wire and wire products, and is used for testing the material properties and fatigue strength of wire.

This machine is suitable for abrupt pull test on power wire and headphone cable of mobile phone, e-book, tablet PC, electronic dictionaries, laptop and headset, etc..

This machine is equipped with 6 sets of clamps to test the folding strength of wires, plug leads and wires for mobile phone/communication industry accessories. The test method is to fix the sample on the clamp and add a certain load. During the test, the clamp swings left and right. After a certain number of times, check the disconnection rate; or when the power cannot be supplied, check the total number of swings. This machine can automatically count. When the sample is bent to the point where the wire is disconnected and the power cannot be supplied, it can automatically stop the operation and alarm.